Xerox_7042_Communication_Error_

ERROR CODE	DESCRIPTION	SOLUTION
001	Operation was stopped by opening the cover.	Close the cover & check the scanner and top cover interlock switches for marginal or intermittent operation. If the problem repeats, go to RAP 26.
002	Document jammed or was too long.	Remove jam and check for proper operation by performing a scanner drive test (05), ADF test method. If the problem continues, go to RAP 40
003	Out of recording paper or jammed and memory was full.	Load paper, remove jam and check for proper operation by performing a printer test (00). If the problem repeat, go to RAP 31.
005	Modem hardware or timing error.	A mechanical error. Perform System Checks.
006	Hardware or timing error.	A mechanical error. Perform System Checks.
008	T1 time-out error. The two machines were trying to identify each other for greater than 35 seconds or busy tone was detected.	Procedures (off-line) do not indicate any problems, go to RAP 54.
009	Final attempt to redial was not successful. .	Check the remote machine. Test the dialing functions
010	T1 timer (35 seconds) timed out while waiting for a response from the transmitter.	A receive error. If the System Checks procedures (off-line and on-line) do not indicate any problems, go to RAP 54.
014	An error occurred in the laser printer or the scanner.	A mechanical error. Perform System Checks.
015	Drum & Drum counter should be replaced or toner is empty.	Check drum counter for proper installation or add toner.
100	A polling request (NSC/CIG/DTC) was initiated and the called machine did not respond within 35 seconds. (T1) .	A polling error. If the System Checks procedures (off-line and on-line) do not indicate any problems, go to RAP 54.
101	A disconnect signal (DCN) was received from the called machine while waiting for it to identify all capabilities (NSF/CSI/DIS).	A transmit error. If the System Checks procedures (off-line and on-line) do not indicate any problems, go to RAP 54.
102	A disconnect signal (DCN) was received from the transmitter after sending local capabilities identification (NSF/CSI/DIS).	A receive error. If the System Checks procedures (off-line and on-line) do not indicate any problems, go to RAP 54.

NOTE: These error codes are showing the display and printed in the Activity Report.